• Vm3 Permaskin can be applied to virtually any dry, clean porous substrate and clean, hard surface. This includes concrete, fibreglass, stainless steel, steel, stucco, acrylic, masonry and sheet rock.
  
  
• it has a tensile strength of 1500 psi
  
  
• Vm3 Permaskin elongates in excess of 200% at 21°C
  
  
• it remains flexible in temperatures as low as minus 31°C
  
  
• its strength and stretch capabilities mean that instead of cracking, Vm3 Permaskin bridges a crack without opening, and at worst simply forms a strong bubble.
  
  
• Vm3 Permaskin does not support combustion. It has a flame spread rating of 23 and zero fuel contribution when tested in accordance with ASTME-84
  
  
• a 500 microns film has a moisture vapour transmission rate of 0.20 perms
  
  
• after 1000 cycles with a Taber CS-17 abrasion wheel, the loss was only 0.006mm
  (ie 6.25 microns)
  
  
• the correct application over the proper primer insures an adhesion of 9kg per 2.5cm², which protects against blistering and delamination. (not applicable where to seal pores, stop vapour transmission and hydrostatic pressure a sealer Campoxy has been applied to the surface)
  
  
• Vm3 Permaskin in UV stabilized

Poly Pools warrants Vm3 Permaskin and workmanship against defects for ten years pro-rata from the date of application. If leaking occurs, the first course is always to pressure test all water pipes associated with the pool. If these results determine that the material is defective, Poly Pools will supply replacement material for the defective area free of charge.

---

[ What is it? ] [ Advantages in Pools ] [ Colours & designs available ] [ Technical data ] [ Vm3 HOME ]

---

Reflections Pool and Spa Care
307 Preston Point Rd, Attadale WA 6156
Telephone: (08) 9330 7330
ABN 95 625 898 762